project:reprap:drevena
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
project:reprap:drevena [2015/11/05 19:49] – yan | project:reprap:drevena [2017/06/10 09:00] (current) – trolling boys in IRC rainbof | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Drevena REPRAP printer ===== | ||
+ | |||
+ | **Current status: <font inherit/ | ||
+ | Todo: | ||
+ | |||
+ | |**What to do** |**wtf** |**status** | | ||
+ | |fix belt position|add more pads between belt holder and heatbed|hackit!| | ||
+ | |replace extruder|reprint missing parts and install it|hackit!| | ||
+ | |increase extruder stability|insert steel sheet sebetween extruder and X axis.|hackit!| | ||
+ | |fix extruder cable position|When extruder is dismounted, is possible manage cables from bottom side to back.|hackit!| | ||
+ | |fix Z axis endstop|replace glue|hackit!| | ||
+ | |fix Y axis endstop|replace silicon with holder|hackit!| | ||
+ | |fix X axis endstop|create end pad on extruder, move endstop to propper distance. (and fix wires…!!)|hackit!| | ||
+ | |identify account management|Find logins and other acces codes to octoprint : | ||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
+ | |||
+ | Drevena means " | ||
+ | |||
+ | === Print Settings === | ||
+ | |||
+ | * [[https:// | ||
+ | |||
+ | === Control board Specification === | ||
+ | |||
+ | * Main board - ATmega 1280 | ||
+ | * printer shield - unknown | ||
+ | * controlled by RPI w Octoprint | ||
+ | |||
+ | === HW specification === | ||
+ | |||
+ | * usable XY size 300 x 200 mm | ||
+ | * extruder - [[http:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | * hotend - unknown | ||
+ | * cooling fan included - it's connected on PC DC source. | ||
+ | |||
+ | === possible/ | ||
+ | |||
+ | * < | ||
+ | * Z axis stopper holder | ||
+ | * < | ||
+ | * < | ||
+ | * imrpove whole extruder | ||
+ | |||