project:reprap:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
project:reprap:start [2016/11/27 05:41] – ruza | project:reprap:start [2017/06/10 08:09] – [Printer status] rainbof | ||
---|---|---|---|
Line 5: | Line 5: | ||
founder=[[user: | founder=[[user: | ||
depends=| | depends=| | ||
- | interested=[[user: | + | interested=[[user: |
status=active| | status=active| | ||
sw=GPLv2+| | sw=GPLv2+| | ||
Line 40: | Line 40: | ||
===== Printer status ===== | ===== Printer status ===== | ||
**[[project: | **[[project: | ||
- | * status: | + | * status: |
* set all **speed max.** to **70** (especially check translation speed), **first layer 30%** and **small perimeters to 50%** **check Z-axis** when starting printing !! | * set all **speed max.** to **70** (especially check translation speed), **first layer 30%** and **small perimeters to 50%** **check Z-axis** when starting printing !! | ||
* printing mechanics in nearly 100% condition (thx 2 [[user: | * printing mechanics in nearly 100% condition (thx 2 [[user: | ||
* web interface: http:// | * web interface: http:// | ||
* **config issues - please check details [[project: | * **config issues - please check details [[project: | ||
+ | |||
**[[project: | **[[project: | ||
Line 50: | Line 51: | ||
* **" | * **" | ||
* web interface: http:// | * web interface: http:// | ||
+ | |||
+ | **[[project: | ||
+ | * Aim to buy a kit of the current state-of-the-art 3D printer that should Finally Work™ | ||
==== Additional status info ==== | ==== Additional status info ==== | ||
* **config issues on drevena - please check details [[project: | * **config issues on drevena - please check details [[project: |
project/reprap/start.txt · Last modified: 2019/03/16 13:01 by pasky