project:reprap:anytime
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
project:reprap:anytime [2015/10/23 12:21] – yan | project:reprap:anytime [2019/08/08 06:55] (current) – [3d printing cookbook] - price update rainbof | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== 3d printing cookbook ====== | ||
+ | |||
+ | === Before === | ||
+ | * check status of printers [[project: | ||
+ | * [[project: | ||
+ | * go to HWlab | ||
+ | * [[project: | ||
+ | * check physically that printers are good to go (filament is on place, bed is nicely covered with homogenous thin layer of glue, bed and axis are moving freely) | ||
+ | * check Z axis position. | ||
+ | * set temperature of bed and extruder (guide [[project: | ||
+ | * if you´re not sure try to extrude 5mm of filament (**EXTRUDER MUST BE HOT**) | ||
+ | * start printing and **check** if the **Z axis** is OK - if not do a " | ||
+ | |||
+ | === In process === | ||
+ | * it´s good to check "once upon a time" if everything is okay - temperature ok, no overheat, printed object sits on bed and don "walks around nozzle", | ||
+ | * if something goes wrong, stop printing. If something goes **really** wrong, pull the printer out of electricity. In any case contact [[: | ||
+ | |||
+ | === After printing [czech] === | ||
+ | * uklidit **bordel** kolem a na reprapu (kousky filamentu, kousky vytištěného filamentu a.t.p.) | ||
+ | * zkontrolovat že je **vypnutý** bed a vypnuté vyhřívání trysky | ||
+ | * v případě že tam zbývá malý kousek filamentu **filament vyměnit** (v rámci pravidla "be excellent to each other" | ||
+ | * v případě závady/ | ||
+ | * < | ||
+ | |||
+ | |||
+ | === After printing [en - short version] === | ||
+ | * clean up the mess | ||
+ | * turn off heating (bed, extruder) | ||
+ | * do not leave few cm of filament in printer, install new filament | ||
+ | * if it broke or you broke it - nevermind, * * * * happens. Report it and leave a note on printer | ||
+ | < | ||
+ | |||
+ | ==== Bed preparation ==== | ||
+ | * if there is printed object on bed put it in plastic box under [[http:// | ||
+ | * Unify layer of glue by slightly (!!!) wet sponge. | ||
+ | * If you use PLA you can use carbon bed. | ||
+ | * If there is too little of glue or you're printing something with unstable base put a little amount of glue on bed. | ||
+ | * If you're printing something with bad adhesion from ABS use ABS/acetone juice. | ||
+ | * If you're printing more ABS parts in series unify layer with pure acetone, dont put too much of juice on glass plate or you'll only end up with dirty glass. | ||
+ | * **KEEP THE GLASS IN CONDITION IN WHICH YOU WOULD LIKE TO FIND IT** | ||