project:circuit_bending:start
This is an old revision of the document!
Table of Contents
Circuit Bending
circuit bending | |
---|---|
![]() |
|
founder: | harvie |
depends on: | |
interested: | |
software license: | |
hardware license: |
- HOWTO
- Get sh*tloads of e-junk
- Connect it to power supply
- Short circuit it a bit (less or more intentionaly)
- Connect two wires with needles on their ends to audio amplifier with speakers
- Randomly try to find noise on the PCB using those needles
- Add few buttons and pots
- Make a NOISEEEEeeeee…
Need your TRASH!
If you have any old electronics that you would othervise throw away, please give it to me for this project.
CyberTrip
I've ordered small strobe from china, so once it arrives i can tune it on 10Hz and synchronize the noise with it. And i believe this can make audience in small darkened room of hackerspace pass to their inner hyperspace (or to photosensitive epilepsy shock).
Books
- Nicolas Collins - Handmade Electronic Music: The Art of Hardware Hacking
Nicolas Collins VideoLessons (groovy!)
- Tutorial 2: In/Out - Electromagnetism Explained (Chapter 4)
- Tutorial 3: Jumping Speakers (Chapter 5)
- Tutorial 4: How to Solder (Chapter 6)
- Tutorial 5: How to Make a Contact Mike (Chapter 7)
- Tutorial 6: Drivers (Chapter 8)
- Tutorial 7: Tape Heads (Chapter 9)
- Tutorial 8: Electret Microphones (Chapter 10)
- Tutorial 9: Laying of Hands (Chapter 11)
- Tutorial 10: Hack the Clock (Chapters 12-15)
- Tutorial 11: Your First Oscillator (Chapter 18)
- Tutorial 12: From Breadboard to Circuit Board (Chapter 19)
- Tutorial 13: On/Off (Chapter 21)
Inspiration
project/circuit_bending/start.1480067787.txt.gz · Last modified: 2016/11/25 09:56 by ruza