===== Alteon AD3 ===== {{:project:networkinglab:alteon_ad3.jpg?400}} ==== Manual ==== {{ :project:networkinglab:alteon-ad3-ad4-180e-212779-a.pdf |}} ==== Factory reset ==== - connect via serial cable (9600 8N1 NOR) - do cold boot using power switch on the back of the box - during first messages scrolling on the terminal press . Default password is "admin". Boot version 10.0.30.7 Press for maintenance kernel Booting maintenance kernel... Enter administrator password: Maintenance Kernel Version 8.0.30 Time: 4:37:08 Sun Mar 26, 2017 ------------------------------------------------------------ [Main Menu] diag - Diagnostics boot - Boot menu cfg - Configuration Menu debug - Debugging Menu >> Main# boot ------------------------------------------------------------ [Boot Options Menu] reset - Reset switch image - Select software image to use on reset conf - Select config block to use on next boot >> Boot Options# conf Currently set to use active config block on next boot. Specify new block to use ["active"/"backup"/"factory"]: factory Next boot will use factory default config block instead of active. >> Boot Options# reset Resetting switch ... Boot version 10.0.30.7 Press for maintenance kernel.... Alteon AD3 Rebooted because of power cycle. Booting complete 4:51:55 Sun Mar 26, 2017: Version 10.0.30.7 from FLASH image1, factory default config block. Enter password: System Information at 4:52:16 Sun Mar 26, 2017 Alteon AD3 sysName: sysLocation: Switch is up 0 days, 0 hours, 0 minutes and 21 seconds. Last boot: 4:51:55 Sun Mar 26, 2017 (power cycle) MAC address: 00:60:cf:46:a1:e0 IP (If 1) address: 0.0.0.0 Hardware Revision: B Hardware Part No: B04_5A-D_7B-A Software Version 10.0.30.7-SSH (FLASH image1), factory default configuration. The switch is booted with factory default configuration. To ease the configuration of the switch, a "Set Up" facility which will prompt you with those configuration items that are essential to the operation of the switch is provided. Would you like to run "Set Up" to configure the switch? [y/n] ------------------------------------------------------------ [Main Menu] info - Information Menu stats - Statistics Menu cfg - Configuration Menu oper - Operations Command Menu boot - Boot Options Menu maint - Maintenance Menu diff - Show pending config changes [global command] apply - Apply pending config changes [global command] save - Save updated config to FLASH [global command] revert - Revert pending or applied changes [global command] exit - Exit [global command, always available] >> Main# save No changes need saving, but since the last boot used the factory default configuration, this save will write that configuration out to FLASH as the "active" config block. Request will first copy the FLASH "active" config to "backup", then overlay FLASH "active" with new config. Confirm saving to FLASH [y/n]: y New config successfully saved to FLASH. Switch is currently set to use factory default config block on next boot. Do you want to change that to the active config block? [y/n] y Next boot will use active config block. >> Main# maint ------------------------------------------------------------ [Maintenance Menu] sys - System Maintenance Menu fdb - Forwarding Database Manipulation Menu debug - Debugging Menu arp - ARP Cache Manipulation Menu route - IP Route Manipulation Menu uudmp - Uuencode FLASH dump ptdmp - tftp put FLASH dump to tftp server cldmp - Clear FLASH dump panic - Dump state information to FLASH and reboot tsdmp - Tech support dump >> Maintenance# panic Confirm dump and reboot [y/n]: y Starting system dump...done. Rebooting at 4:55:40 Sun Mar 26, 2017... ==== Internals ==== [[https://goo.gl/photos/6mbnfbr3zLt5dA9N6|fotky]]