This is an old revision of the document!


Vaisala weather sonde hardware

Sensors stick

TODO image

name description
tempC temperature sensor (capacittive ?)
HUM1 humidity sensor 1
HUM2 humidity sensor 2
temp2 thermistor

Connectors

name description
CON1 service connector - used for sonde tweaking (and programming?)
CON2 external sensors connector
CON3
CON4 service connector + other
CON5
CON6
CON7
CON8
  • GPS antenna: 3dBic (dB - isotropic circular), RHCP, omnidiractional

pinouts

Pinouts as used in this project.

CON1 pin description
1 GND
2 +9Vcc - 9 V
3 ? (to u-controller pin 27, pull-up)
4 ? (to u-controller pin 26, floating)
5 ? (to u-controller pin 45, pulled-down)
6 NC
7 ? (to u-controller pin 46, pull-up)
8 SPI_SS_EEPROM - SPI select EEPROM
9 SPI_MOSI
10 SPI_CLK
11 SPI_MISO
12 RESET - ground to switch into service mode
CON4 pin description
1
2
3 GND
4 GND
5 ? (to u-controller pin 27, pull-up)
6 ? (to u-controller pin 26, floating)
7 ? (to u-controller pin 45, pulled-down)
8
9 ? (to u-controller pin 46, pull-up)
10 SPI_SS_EEPROM - SPI select EEPROM
11 SPI_MOSI
12 SPI_CLK
13 SPI_MISO
14 RESET - ground to switch into service mode
15
16 +2V8cc - 2.8 V, generated by regulator (IC ?? TODO) from +9Vcc

TODO: the following must be re-checked

CON5 pin description
1 Logic VCC (3.45V)
2 Serial Clock (2400Hz)
3 Serial Data (2400 Baud)
4 TX Enable? Stays low when clock starts, but goes high later (when serial data is present)
5 SPI Data Input
6 GND
7 16MHz clock from GPS Module
8 GND
9 SPI Clock
10 TX Programming?? - Could be Chip Select
11 Internal LDO Inhibit. Is wired to the module's LDO regulators Inhibit pin via 10k resistor.
12 TX Inhibit - Connected to Base of Switching transistor inside module.
13 Main Power - Measured Battery Voltage on this pin (12V in my case)
14 GND

TODO: other connectors

Parts - Integrated curcuits description

IC1 - SPI EEPROM

  • type: M95256
  • description: 256 kbit SPI EEPROM

IC2

  • type: DSP1C
    VAISALA
    1037C
    03004
  • package: 64-TQFP (4×16 leads square)
  • description: controller, details unknown (CPU, ASIC? DSP?)

DSP1C is made and developed by VLSI specificaly for VAISALA. Is based on VS-DSP (ver 1. ?) DSP core. No more information can be provided by VLSI.

IC3

  • type: uN8021C (TODO)
  • description: GPS FR fronend
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki